Garland Rain Diverter Kit

This Garland Connection System Kit for Rain Drain automatically carries water from your drainpipe to the rain barrel. This connection system is also called Rain Diverter Kit. Fits standard 68mm round or 65mm square plastic downspouts (not suitable for cast iron downspouts).

Note: Do not use an electric drill if the rain barrel contains water.

Instructions for use

• Take the lid off the water butt. If your water butt is not predrilled then you will need to drill a 25mm hole to fit the rain diverter;
• Drill a 25mm hole near the top of the water butt on the side closest to the down pipe (some water butts may have drill points indicated). Push connector through the washer from inside the butt, then fit and tighten the nut on the outside to form a seal;
• Position water butt with tap facing forward and adjust to down pipe. If using a stand place the butt on it. Mark the down pipe 10mm below the top of the butt. Mark again 30mm below this point, using a hacksaw. Cut out this section;
• Fit rain diverter with square end up into the cut section of the down pipe. Release any clips supporting the down pipe in order to insert the rain diverter body and refit once diverter is in place;
• Connect hose between rain rain diverter body and the water but connector.

Specifications

• Artikelnumber Garland: W1870;
• Included: 1 x Rain Diverter, 1 x 20mm Connector, 1 x Washer, 1 x Nut, 1 x 500mm Hose.